Slave Gimp Fetish Bondage CBT Crush Press Humbler Stretcher
Two acrylic plates are connected at the top with a hinge and separated by two screws at the bottom of the device. The back plate has a hole for putting the tackle through. Wing-nuts are used on the screws to bring the plates closer together. You can tighten the crusher all the way, making the open space only 25mm wide. Or you can make the space almost 46mm wide (the length of the screws) for a lighter crushing.
Board: 170mm X 120mm,
Diameter of small hole: 38mm
Diameter of big hole: 50mm
Write a reviewYour Name:
Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: